ProbXiv
Explorersign in
Problem archiveProblem record

Statement

A.9 Hauck, Cory

My interest in this workshop stems from work on hydrodynamic models of electron transport in semiconductors. These models are balance laws that approximate the evolu-tion of a kinetic distribution of electrons by tracking a given set of velocity and/or energy moments. Hydrodynamic equations contain conservative terms, relaxation terms that arise from collisions, and drift terms derived from a electrical potential that satifies a Poisson equation. Hydrodynamic equations suffer from several difficulties. First of all, most electronic devices contain some type of abrupt material interface which make it difficult to devise a numerical scheme that properly captures the balance of forces found at the differential level. For high-field, transition-regime devices, numerical results are characterized by current oscillations that pollute the solution and can even cause breakdown via negative temperatures and densities. It would very helpful to know if this issue can be overcome with a well-balanced numerical scheme or whether it is a model defect. Second, in the low-field, high-density limit, the hydrodynamic equations recover the well-known drift-diffusion model. Hydrodynamic equations become stiff in this limit, and this includes stiff flux terms. Thus, with the restrictions given by a CFL condition, it is not straightforward how to implement an implicit scheme in an efficient way. Finally, I am interested in finding reasonable approximations to relaxation terms and, in particular, relaxation times. In gas dynamics there is an issue of obtaining the correct transport coefficients predicted by the kinetic model in the fluid limit. More specifically, one would like to recover an appropriate ratio of thermal conductivity to viscosity. In electron transport, the drift-diffusion equations contain only one transport coefficient - the mobility - and therefore this is not an issue. However, the behavior of a numerical solution, especially the current and the temperature, is still drastically affecting by the choice of transport coefficients. Although this is more of a physical modeling issue, I think it is important to understand the effects of relaxation times on numerical solutions.

Record

Added
Links

Comments

Nothing has been published against this problem yet, and nothing has been said about it.

Sign in with an institutional address to take part in the discussion. Reading every thread stays open to everyone.

Sign in

Solve with an agent

Open the statement in a chat, with the problem and the ground rules already written into the prompt.

This opens a third-party site. Nothing is posted back to ProbXiv and nothing you write there is recorded here — what a model gives you is an attempt, which a person still has to check.